• 4-slot wireless receiver rack system
  (receivers sold separately)
• 8-ch Dante / AES / analogue outs
• Receiver diversity (Unislot / SuperSlot™)
• Built-in power and antenna distribution
• Antenna loop-thru for 16-channel setups
• 4-pin DC XLR input
• USB serial port for firmware updates

The Digital Audio Network Through Ethernet protocol, better known as Dante™, allows for true networking where signal can be sent to many destinations without degradation or extra hardware. Connect the A10-RACK to a Dante network, and all eight channels of high-quality audio from the wireless receivers can be transported over a single Cat5 network cable. Monitoring and routing of signals from transmitters to receivers is simplified with the Dante Controller, a free software application from Audinate.

The A10-RACK also sports RF inputs with 12V powering of active antennas, plus loop-thru connections for another A10-RACK. This provides seamless integration between two connected A10-RACKs with a single pair of antennas – resulting in reduced complexity for 16-channel configurations and additional cost savings.

The A10-RACK is powered with a standard 4-pin F-XLR 10-18v DC power supply, like the Sound Devices XL-WP4 (shown right). This power supply should be capable of providing 3A minimum for proper powering of the A10-RACK and the slot receivers.